Shear Bond Strength of a 3-in-1 Flowable Composite Resin to Primary Teeth

Hyeongjik Lee; Jonghyun Shin; Jiyeon Kim; JEONG,TAE-SUNG; Shin Kim

doi:10.5933/JKAPD.2018.45.4.436

The purpose of this study was to compare the shear bond strengths of 3-in-1 flowable composite to the enamel and dentin of primary teeth to previous adhesive systems. 110 primary incisors were prepared and divided into two groups: Dentin group included 5 groups: 1) Scotch bond Multi-purpose plus(DSM), 2) Single-bond 2(DSB), 3) Clearfil SE bond(DSE), 4) All bond universal(DAB), 5) Constic(DC), and Enamel group included 6 groups: 1) Scotch bond Multipurpose plus(ESM), 2) Single bond 2(ESB), 3) Clearfil SE bond(ESE), 4) All bond universal(EAB), 5) Constic(EC), 6) Constic with additional etching(ECE). A cylinder of composite was bonded to the prepared surface, and the shear bond strength was measured. In the dentin groups, group DC had significantly lower shear bond strength than group DSE. No significant difference was found between group DC, group DSM, group DSB and group DAB. In the enamel groups, there was no significant difference between group EC, group ESE, and group EAB. This material showed lowest shear bond strength among all tested materials in both enamel and dentin groups, showing insignificant difference with some adhesive systems. Therefore, 3-in-1 flowable composite can be used for primary teeth restoration but further studies are needed.

Citation status

KCI Citation Counts (0)
REFERENCES (25)
열림/닫힘 버튼
* 2021년 이후 발행 논문의 참고문헌은 현재 구축 중입니다.

[journal] Buonocore MG / 1955 / A simple method of increasing the adhesion of acrylic filling materials to enamel surfaces / J Dent Res 34 : 849~853

[journal] Kanemura N / 1999 / Tensile bond strength to and SEM evaluation of ground and intact enamel surfaces / J Dent 27 : 523~530

[journal] Rotta M / 2007 / Effects of phosphoric acid pretreatment and substitution of bonding resin on bonding effectiveness of self-etching systems to enamel / J Adhes Dent 9 : 537~545

[journal] Van Landuyt KL / 2006 / Bond strength of a mild self-etch adhesive with and without prior acid-etching / J Dent 34 : 77~85

[journal] Ahmad I / 2003 / Evaluating dentin bonding agents: an update / Pract Proced Aesthet Dent 15 : 529~536

[journal] Gwinnett AJ / 1994 / Dentin bond strength after air drying and rewetting / Am J Dent 7 : 144~148

[journal] Selvaraj K / 2016 / Evaluation of microshear bond strength and nanoleakage of etchand-rinse and self-etch adhesives to dentin pretreated with silver diamine fluoride/potassium iodide: An in vitro study / Indian J Dent Res 27 : 421~425

[journal] Kanca J / 1992 / Effect of resin primer solvents and surface wetness on resin composite bond strength to dentin / Am J Dent 5 : 213~215

[journal] Atash R / 2005 / Bond strengths of eight contemporary adhesives to enamel and to dentine: an in vitro study on bovine primary teeth / Int J Paediatr Dent 15 : 264~273

[journal] Beloica M / 2010 / Microtensile vs microshear bond strength of all-in-one adhesives to unground enamel / J Adhes Dent 12 : 427~433

[journal] Kahveci O / 2011 / Composite bond strength to intact enamel with current simplified adhesives / J Adhes Dent 13 : 31~37

[journal] Miranda C / 2010 / Microtensile bond strength of 4 dentin adhesives to primary dentin / J Dent Child (Chic) 77 : 126~134

[journal] Sarr M / 2010 / Microtensile bond strength and interfacial characterization of 11 contemporary adhesives bonded to bur-cut dentin / Oper Dent 35 : 94~104

[journal] Torres CR / 2017 / Influence of previous acid etching on bond strength of universal adhesives to enamel and dentin / Gen Dent 65 : 17~21

[journal] Yadala C / 2015 / Comparison of Shear Bond Strength of Three Self-etching Adhesives: An In-Vitro Study / J Int Oral Health 7 : 53~57

[journal] Nakabayashi N / 1982 / The promotion of adhesion by the infiltration of monomers into tooth substrates / J Biomed Mater Res 16 : 265~273

[journal] Bordin-Aykroyd S / 1992 / In vitro bond strengths of three current dentin adhesives to primary and permanent teeth / Dent Mater 8 : 74~78

[journal] Hirayama A / 1990 / Experimental analytical electron microscopic studies on the quantitative analysis of elemental concentrations in biological thin specimens and its application to dental science / Shika Gakuho 90 : 1019~1036

[journal] Garberoglio R / 1976 / Scanning electron microscopic investigation of human dentinal tubules / Arch Oral Biol 21 : 355~362

[journal] Nör JE / 1996 / Dentin bonding:SEM comparison of the resin-dentin interface in primary and permanent teeth / J Dent Res 75 : 1396~1403

[journal] Sasakawa W / 2005 / Micro-shear bond strength of five single-step adhesives to dentin / Dent Mater J 24 : 617~627

[journal] Roh OD / 2005 / Micro-shear bond strength of five resin-based composites to dentin with five different dentin adhesives / Am J Dent 18 : 333~337

[journal] Davidson CL / 1984 / The competition between the composite-dentin bond strength and the polymerization contraction stress / J Dent Res 63 : 1396~1399

[journal] Suliman AA / 1993 / Cusp movement in premolars resulting from composite polymerization shrinkage / Dent Mater 9 : 6~10

[journal] Schuldt C / 2015 / Shear Bond Strength and Microleakage of a New Self-etching/Selfadhesive Pit and Fissure Sealant / J Adhes Dent 17 : 491~497

KJC Korea
Journal Central

Statistics

Tools

Sharing

Issue List

Citation status